Kibosh.com

Step 1: Starlink Router Prep

If you have a Starlink Router model UTR-232 skip to Step 2.

Otherwise, you will need the Starlink ethernet adapter.

• Watch Starlink Ethernet Adapter Quick Setup video.

Step 2: put the Starlink into Bridge-Mode

• Watch How to set your Starlink to Bridge-Mode

Step-by-step:

1. Connect to Starlink’s WiFi
2. Log into your Starlink app
3. Go to Main Router
4. Go to Settings
5. Choose Router (not Starlink)
6. Go to Bypass Mode
7. Slide to Bypass

Step 3: install the Kibosh MT6000:

1. Take the Ethernet Patch cable that came with your Kibosh Router
   • A) one end plugs into your Starlink Router’s…
     • ethernet adapter (as shown here)
     • OR if you have a UTR-232 it plugs into the far left port
   • B) the other end plugs into the MT6000 WAN port
     • See where the MT6000 WAN Port is here
2. Power-cycle reboot (pull power chord) on BOTH the Starlink router and the Kibosh router.
3. Wait for about 5 minutes while both routers reboot and link up:
   • ** AT THIS POINT: Kibosh MT6000 is now your main WiFi router
   • A) look for the new ‘Kibosh‘ WiFi network, and join using password: abcd0001
   • B) then log into your Kibosh Portal
     • you’ll need to create an account if you haven’t already
   • C) On your Portal > Home the Internet Status should be Protected
4. Go to Portal Orientation to get started using your Kibosh

How to put Starlink back into it’s original state:

• How to factory reset (i.e., restore to normal) your Starlink Router.